Filter
Top Products
17
MAN-RCKPC-001 MC100 Series Rack Mount Computer
Expansion Card Installation
The Rack Mount Computer can accommodate up to 3 PCI expansion cards, 2
ISA expansion cards and one PICMG expansion card. To install an expansion
card:
1. Disconnect the power source from the Rack Mount Computer.
2. Open the enclosure to install the expansion cards, by removing the
two thumb screws at the top of the rear panel that secure the housing
cover. Lift the housing cover off of the chassis.
3. Remove the screw that secures one end of the card retainer rail and
lift up. (The rail is hinged on the other end.)
4. Remove and set aside the screw that secures the slot cover where
the expansion card will be installed. Remove and discard cover.
7 MAINTENANCE AND UPGRADES
Card Retainer Rail
Hinged End
Card Retainer Rail Screw
Retainer Foot Screw
Slot Cover
Screw (7)
Card Retainer Foot
Upgrades
CAUTION: Before opening the Computer or handling any expan-
sion cards, be sure to protect the equipment from electrostatic
discharge (ESD) by properly grounding yourself.