Filter
Top Products
+COPS – GSM Network
This command requests accessible networks and sets the GSM home network.
Defined parameters:
<mode> <format>:
0: automatic (standard) Format of <oper> parameters
1: manual 0: long alphanumeric format
2: logoff; device is logged off until 1: short alphanumeric format
<mode>=0 or 1 is selected. 2: numeric format (standard) and <stat>
3: writes <format> (for output with AT+COPS?) Status of <oper>
4: manual / automatic (<oper> required)
<stat> <oper>: Service Provider ID
0: unknown long alphanumeric format: 16 chars
1: available short alphanumeric format: 8 chars
2: active numeric format (standard) and <stat>: 5 chars
+CMGS – Send SMS
The Command sends SMS.
For sending the message,<Strg-Z> (ASCII26) must beentered. Thetext may contain any cha
-
racter except <Strg-Z> and <ESC> (ASCII 27).
Defined parameters:
<da>: <mr>:
Recipient number message reference number, (will be counted up automatically)
(Ring buffer, 0-255)
AT Commands MIM-G01 Appendix
8-4 MITSUBISHI ELECTRIC
Command Possible answers
AT+COPS?
Note: request current network
+COPS: <mode>,<format>,<oper>
OK
AT+COPS=?
Note: request list of available networks
+COPS: (<stat>,"long <oper>","short <oper>","numeric <oper>")
OK
AT+COPS=0
Note: logon to the home network
OK
Note: successful
AT+COPS=<mode>,<format>,<oper>
Note: set network
OK
Note: successful
Tab. 8-8: +COPS – GSM Network
Command Possible answers
AT+CMGS= <da><CR>
text entry<Strg-Z / ESC >
+CMGS: <mr>
OK
Note: transmitted ok
Tab. 8-9: +CMGS – Send SMS