Filter
Top Products
754 Out of ribbon or ribbon jam. Check or load ribbon.
Remove any slack in the ribbon by turning the take-up
reel clockwise.
755 Printhead is open. Close the printhead.
756 Out of supplies. Load supplies.
757 Reload supplies (supply length mismatch).
758 The supply was not seen or the on-demand sensor is
not working correctly. Check for a supply jam, clear the
supply path, or reload supplies. This error may occur if
you remove a label too quickly in the on-demand mode.
The printer does not recalibrate after this error.
759 Knife is not moving. Call Technical Support.
760 Knife jam. Remove any jammed tags from the knife.
Call Technical Support.
761 Stacker is full or jammed. Empty the stacker or clear
the jam before continuing. The printer does not
recalibrate after this error.
762 Low battery. Recharge the battery.
763 Waiting to dispense label. Press Feed.
764 Verifier failure. Press Clear to clear the error and
continue printing. A blank label feeds and the last label
reprints.
765 The printhead has less than four bad dots. The printer
can shift bar code fields to avoid bad dots. Press Clear
to continue printing. Print a test label to confirm the
number of bad dots.
768 Printhead has more than 10 bad dots or is not
connected. Make sure the printhead is connected. If
necessary, call Customer Service to order a new
printhead or printhead kit.
Troubleshooting 11 - 13