Filter
Top Products
7. Close the printer.
Make sure the ribbon is wound tightly inside the ribbon
cassette before you close the printer. See "Reloading a
Ribbon Cassette" to wind the ribbon.
8. Turn the printer on.
9. Wait until the LED flashes one time (about five seconds)
and then press the trigger. The printer calibrates the label
strip for printing. When you print, labels peel automatically
through the upper opening in the label guide and the
backing paper exits out the lower opening.
The LED slowly alternates flashing amber and green to
indicate the printer is out of labels. When this happens, load a
new roll of labels and press the trigger to clear the error.
Label
Guide
Lower
Opening
Upper
Opening
Trigger
LED
9494 Operator’s Handbook
2-10