Filter
Top Products
a. POWER: power indicator
b. CONNECT: checks if the Video Server is alive
c. SERIAL: checks if the RS-232/485 COM ports are in use
As soon as the administrator plugs in the power connector, both the CONNECT and SERIAL
LED’s will flash, one by one, until the diagnosis is finished. If the result is good, these 2 LEDs
will turn off momentarily, and then follow the pattern shown in the table below. If any of the
modules fails, refer to Chapter 7, Troubleshooting, under Power On Self Test for the error
pattern, and then follow the troubleshooting procedures. If the system still does not operate
normally, please contact your reseller for technical service.
Mode Condition
LED1
(POWER)
LED2
(CONNECT)
LED3
(SERIAL)
Before installation ON OFF OFF
After installation ON Flash OFF
Ethernet Connection
During camera control ON Flash Flash
Modem Dial-up
Connection
After POST ON Flash ON
Before connected ON ON ON Null Modem Dial-up
Connection
After connected ON Flash ON
7: Network LEDs: “ACTIVE,” “LINK,” and “FDX”
When using the 10/ 100 Mbps Ethernet connection, VPort 2140 has 3 LEDs to show network
status:
Name Description Work Status
ACTIVE Check if the network is alive Flashing: Network alive
OFF: Network not alive
LINK Check the 10/ 100 Mbps Ethernet speed ON: 100 Mbps
OFF: 10 Mbps
FDX Check if transmission is full or half duplex ON: Full Duplex
OFF: Half Duplex
VPort 2140 User’s Manual
1-6