Filter
Top Products
Accessing VPort 2140 Video Server for the First Time
In Null Modem Mode
Administrators can connect to http://200.1.1.1 from the web browser directly via the null modem
cable. 200.1.1.1 is VPort’s default IP address for the dial-up connection; and 200.1.1.100 is the IP
address assigned by VPort to the user’s PC. The user name and password are the same as what
were entered during the software installation. After successful authentication, administrators
should see the motion pictures on the main page. When using Microsoft Internet Explorer,
administrators must allow the installation of a plug-in provided by the VPort prior to viewing
motion pictures.
In Modem Mode
To dial the VPort, you need to establish a dial-up connection with the PC, in which the dial-up
phone number is the same as the phone line connected to the VPort. After the connection is
successfully established, open the Web browser and link to http://200.1.1.1. In this case, the VPort
runs as a dial-up server and assigns the IP address of 200.1.1.100 to the PC at the other end. When
the authentication message window appears, type root for user name and use VPort’s serial
number for the default password. The point-to-point connection allows users to connect to the
VPort for surveillance purpose at any time.
After the connection is successfully established, follow the instructions described in the next
chapter, Accessing VPort 2140 Video Server for the First Time.
Mounting VPort 2140
Panel Mounting
Users can mount the VPort 2140 Video Server directly to the wall by using the 4 L-type Fixed
Aluminum pieces. First, attach these 4 L-type Fixed Aluminum pieces to the VPort 2140 with the
8 screws. Then use the screws that have diameter larger than 7 mm to mount the VPort 2140 to
the wall.
VPort 2140 User’s Manual
2-14