Filter
Top Products
16
Models MT5600ZDX & ZDXV
The ZDX has no special placement restrictions, but we recommend that
you place it where you can see the indicators on the front panel.
Installation Process
To install the modem mechanically, you must connect the serial datalilne,
phone line, and the power cord to their proper connectors.
RS232
PHONE LINE
RJ11/Phone Connection
RJ11/PSTN Connection
Power Connector
(to Transformer)
DB25 to Computer
POWER
Figure 2-2. Modem Connections
To install your modem:
1. Attach modem to dial-up phone line using the RJ11 telephone cord provided
with it. Plug one cable end into the telephone jack; plug the other cable end
into the LINE jack on the modem.
NOTE
The LINE jack is not interchangeable with the PHONE jack (see rear of
modem, Figure 2-2). Do not plug the telephone into the LINE jack or the
line cable into the PHONE jack. BABT regulations require that the
telecommunication cable be connected to the modem prior to being
connected to the network.
2. Attach the modem to your PC or terminal with an RS232 (or V.24) cable (see
Figure 2-1 and Figure 2-2). Be sure to tighten the mounting screws on the
DB connectors.
3. Connect your telephone set to the phone jack using the RJ11 cable.
4. Attach the modem to the AC Power transformer and plug the AC connector
into a live AC outlet.
NOTE Use only the power
supply shipped with the modem. Use of any other power supply will void
the warranty and could damage the modem.