Filter
Top Products
58
Models MT5600ZDX & ZDXV
If N0 command is active, S37 = 10 updates the +MS command
subparameters to reflect +MS = 10,1,300,12000.
IF N1 command is active, S37 = 10 updates the +MS command
subparameters to reflect +MS = 10,0,12000,12000.
S37 is not updated by the +MS command.
Use of the +MS command is recommended instead of the Nn and S37 =
x commands. Nn and S37 = x commands are supported for compatibility
with existing communications software.
Bits 0-4 Desired line connection speed. If an invalid number is entered,
the number is accepted into the register, but S37 will act as if the default
value has been entered.
0 = Attempt automode connection. If N0 is active, connection is
attempted at the most recently sensed DTE speed (+MS command
settings are updated to the most appropriate values). If N1 is active,
connection is attempted at the highest possible speed (+MS settings are
updated to 11,1,300,2880 to reflect V.34, automode, 300 bps minimum
speed, and 28800 bps maximum speed)--Default.
Register Unit Range Default Description
S38 decimal 0255 20 This register specifies the delay
between the modems receipt
of the H command to disconnect
(or ON-to-OFF transition of DTR
if the modem is programmed to
follow the signal), and the dis-
connect operation. Applicable
to error-correction connection
only. If S38 is set to a value
between 0 and 254, the waits
for the remote modem to ac-
knowledge all data in the modem
buffer before disconnecting. If
S38 is set to 255, the modem
does not time-out and continues
to attempt to deliver data in the
buffer until the connection is lost
or the data is delivered.