Filter
Top Products
90
Models MT5600ZDX & ZDXV
International Modem Restrictions
Some dialing and answering defaults and restrictions may vary for
international modems. Changing settings may cause a modem to become
non-compliant with national telecom requirements in specific countries.
Also note that some software packages may have features or lack
restrictions that may cause the modem to become non-compliant.
Compliance with BABT Requirements
Approved for connection to telecommunications system specified in the
instructions for use subject to the conditions set out in them.
Warning: Interconnection directly, or by way of other apparatus, of ports
marked "SAFETY WARNING see instructions for use" with ports marked
or not so marked may produce hazardous conditions on the network.
Advice should be obtained from a competent engineer before such a
connection is made.
This apparatus has been approved for the use of the following facilities:
Auto-calling
Loop disconnect and MF dialing
Phone number storage and retrieval by a predetermined code
Operation in the absence of proceed indication
Automatic storage of last number dialed
Tone detection-busy
Auto clear from the originating end
DTR dialing
Modem
PBX timed break register recall
European Low Voltage Directive
When correctly installed and maintained, the modem will present no hazard
to the user. When correctly installed the modem will be connected to the PSTN
or a PW and to a Data Terminal Equipment (DTE), whose modem connections
comply with ITU recommendation V28. The DTE connections are therefore
taken to be safe voltages (less than ± 30 volts).
The main power source shall be installed near to the equipment and shall be
easily accessible. The plug that connect to the apparatus to the main power
supply must be fitted with a 5A fuse that complies with BSI1362.