Multitech MVP210 Manual

A SERVICE OF

next previous

 Chapter3–InstallingSoftware

MultiVOIP®Voice/FaxoverIPGateways 21

SettingIPAddress

Forbasicoperationoftheunit,youmustsetauniqueLANIPaddressaswellasasubnetmaskandGatewayIP.

Othersettingscontrolspecificfeaturesandprotocols.Thesesettingsarenotnecessaryforbasicoperation.

Chapter4describesallsettings.



ToconfigureIPsettings:

1. Ifyouareusingpacketprioritization:

a. CheckPacketPrioritization.

b. Set802.1pPriorityParametersasneeded.ThePrioritylevelscanbefrom0–7,where0islowest

priority.VLANIDidentifiesavirtualLANbyanumber(1to4094)

2. FromtheFrameTypedrop‐downlist,selecttheFrameTypethatmatchesthenetworktowhichthe

MultiVOIPisattached:TYPEIIorSNAP

3. EnterGatewayName.

4. IfDHCPisused,checkEnableDHCP.

5. EnterIPAddressfortheMultiVOIPunit.

6. EnterSubnetIPMaskfortheMultiVOIPunit.

7. EnterGatewayIP. 

8. Ifdesired,checktheEnableDNScheckbox.