Filter
Top Products
66
DataTalker Owner’s Manual
6.1 Introduction
The menu system for the DataTalker provides a set of user-friendly configuration menus that are
accessible from a main menu. The Main Menu contains five options that allow you to configure
your DataTalker, display statistics, reset options, run diagnostic tests, and exit the command
mode.
Main Menu
1 - Configurations
2 - Statistics
3 - Reset Options
4 - Diagnostics
5 - Exit Command Mode
6 - QUICK SETUP
Selection : _
To select one of the options from the Main Menu, enter the number corresponding to the option
and press ENTER. A submenu is displayed that allows you to configure your DataTalker; display
statistics; reset a voice/fax channel, data channel or the complete unit; or run one of many
diagnostics tests.
6.2 Configurations Menu
From the Configurations menu you can configure the data port, voice/fax channel(s), or
composite link; display factory defaults; store all current configurations; or return to the Main
Menu.
Configurations
1 - Data Port Configuration
2 - Voice/Fax Channel(s) Configuration
3 - Composite Link Configuration
4 - Factory Default Configuration Options
5 - Configure Remote Unit
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
To configure the data port, voice/fax channel(s), or composite link, enter the corresponding option
number and press ENTER. To change to factory defaults, enter number 4 and press enter. You
can set factory defaults for the entire unit or for only the composite link, data channel, or the
voice/fax channels. Select the option you wish to change, and a message will appear on your
screen saying to wait for 10 seconds. Then press ENTER to return to the Main Menu. To store
the current configuration, enter S and press ENTER. To return to the Main Menu, enter M and
press ENTER.