Filter
Top Products
Mechanical Installation & Cabling MultiVOIP User Guide
72
Cabling Procedure for MVP210
Cabling involves connecting the MultiVOIP to your LAN and telephone
equipment.
1. Connect the power cord supplied with your MultiVOIP to the power
connector on the back of the MultiVOIP and a live AC outlet as
shown in Figure 3-11.
10BASET
COMMAND PORT
POWER
Ethernet Connection
Command Port Connection
Power Connection
E&M
FXS/FXO
FXS/FXO
RS232
COMMAND
10/100
POWER
ETHERNET
E&M
Voice/Fax Channel 1 - 2
Connections
GND
PSTN
E&M
FXO
FXS
E&M FXO/FXS
CH1 CH2
Figure 3-11: Cabling for MVP210
2.Connect the MultiVOIP to a PC by using an RJ-45 (male) to DB-9
(female) cable. Plug the RJ-45 end of the cable into the Command port
of the MultiVOIP and the other end into the PC serial port. See Figure
3-11.
3. Connect a network cable to the ETHERNET 10/100 connector on the
back of the MultiVOIP. Connect the other end of the cable to your
network.
4. If you are connecting a station device such as an analog telephone, a
fax machine, or a Key Telephone System (KTS) (FXS interface), or a
PBX extension (FXO interface) to your MultiVOIP, connect one end of
an RJ-11 phone cord to the Channel 1 FXS/FXO connector on the
back MultiVOIP and the other end to the device or phone jack. You