Filter
Top Products
27
Chapter 4 - Telnet
Router IP Address
Enter the IP address assigned to the RF802EW on your local network. The new address will take
effect after you have selected Save and Restart Server.
Router Subnet Mask
Enter the subnet mask for your local network.
Router Name
Enter a network name for the RF802EW. If your ISP requires your device to have a name, you may
use the value entered in this field.
Router Password
The default is no password. If you choose to use a password, ensure that you write the password
down and keep it in a safe place. If you forget the password, contact the Multi-Tech Technical
Support for assistance. Refer to Chapter 10 in this User Guide for contact information.
WAN Ethernet MAC addr.
Displays the current MAC address of your router. Edit this only if required by your remote system or
ISP.
WAN Ethernet Settings
Define the function of the WAN port by selecting Internet Access (IP Routing-NAT Enabled) or LAN-
to-LAN access (IP Routing-NAT Disabled). Refer to the WAN Ethernet Segment section of the
RouteFinder Manager chapter for more information.
Internet Access
If you use the WAN port for Internet Access, you must configure the following options:
Enter the IP port information provided by your ISP or other external network administrator.
Note: If your ISP uses dynamic IP addressing, leave the External Port IP address and External
Gateway IP address at the default values of 0.0.0.0. Set the External IP Netmask to the default
value of 255.255.255.0.
LAN -to- LAN Access
To use the WAN port to connect to another LAN, you must configure the following:
Enter the IP and Netmask address of the network to which you are connecting.