Filter
Top Products
35
Chapter 5 - RouteFinder Manager
LAN Ethernet Segment
Server IP address
This IP address is the internal LAN IP address of the RF802EW. The address entered into the
Setup Wizard is displayed here (for example, 192.168.2.1).
Server IP Netmask
The RF802EW subnet mask generally can be left at the default value of 255.255.255.0.
WAN Ethernet Segment
Select NAT (Network Address Translation) to provide firewall protection and enable all local
LAN users to share one IP address to access the Internet. If the NAT box is not selected, the
WAN Ethernet is configured as a router to route network traffic between the LAN Ethernet
segment and the WAN Ethernet segment. The External Port IP Addresses are provided by your
ISP or remote system administrator.
PPPoE
If your ISP uses Point-to-Point Protocol over Ethernet for authentication purposes, select the
PPPoE box and enter your ISP account User Name and Password.
External Port IP Address
Enter the IP address provided by your ISP or remote system administrator.
External Port IP Netmask
Enter the subnet mask of the port as provided by your ISP or remote system administrator.
Gateway IP Address
Enter your ISP or remote network’s Gateway IP address.
Note: If your ISP uses a DHCP server to automatically assign a login IP address, subnet mask,
gateway IP address or DNS IP address, enter 0.0.0.0 as your External Port IP Address and the
Gateway IP Address.
Async Port
The Async Port can be configured to provide either IP Routing or Remote Access. IP Routing is
used to connect your network to another router through the Serial async port. Remote Access allows
remote users to dial-in to the device to access and share network resources as if they were logged
on to the network locally.
1. To configure the RF802EW for IP Routing, select IP Routing in the Async Port section of the
General Settings dialog box.
2. Click PPP Settings.