Filter
Top Products
47
4 TROUBLESHOOTING
E
Points to check with possible solutions
Try adjusting the convergence in the
ScreenManager’s Screen menu.
See page 24.
This problem can occur when using BNC
connection and the termination switch is set
incorrectly. The termination switch should be set
to 75 Ω for a connection to a single monitor. See
page 11.
Change the mode of “Signal Filter 1” function in
the ScreenManager “Others” menu. See page 37.
This may be solved by changing the refresh rate.
Decrease the vertical bars at the “Signal Filter 2”
function in the ScreenManager “Others” menu.
See page 37.
Go to the ScreenManager’s “Screen” menu.
Switch on the moiré reduction feature and adjust
as necessary. See page 24.
Change the horizontal and vertical dimensions of
the display area.
Change the selected desktop or wallpaper pattern
to any solid color pattern. For detailed
information on how to change these patterns, refer
to the documentation for the PC and operating
system.
Flicker will occur with interlaced scanning, or
non-interlaced scanning with a low refresh rate.
All EIZO monitors are capable of reproducing
high refresh rates for non-interlaced scanning. If a
problem occurs when using a non-interlaced
signal, try adjusting the graphics board to increase
the refresh rate (if possible). Refer to the graphics
board manual for information.
Problems
5) The image has a background
shadow.
6) The characters and images
have a slight shadow on their
right side.
7) The characters and images
have several vertical bars on
their right side.
8) Moiré patterns are
distracting.
9) The image is flickering.