Filter
Top Products
Appendix D Windows 98/95: Troubleshooting and Common Questions
NI-488.2 User Manual for Windows D-2 www.natinst.com
EDVR Error Condition with ibcntl Set to 0xE0140035 (–535560139)
If a call is made with a device name that is not listed in the logical device
templates that are part of the NI-488.2 Configuration utility, an EDVR error
condition occurs with
ibcntl
set to 0xE0140035.
EDVR Error Condition with ibcntl Set to 0xE0320029 (–533594071) or
0xE1050029 (–519765975)
If a call is made with an interface number that is assigned to a GPIB
interface that is unusable because of a resource conflict, an EDVR error
condition occurs with
ibcntl
set to 0xE0320029 or 0xE1050029.
This error is also returned if you remove a PCMCIA-GPIB or
PCMCIA-GPIB+ while the driver is accessing it or if you try to
access a PCMCIA-GPIB when 32-bit PCMCIA drivers are not enabled.
To enable the 32-bit PCMCIA drivers, complete the following steps:
1. Select Start»Settings»Control Panel.
2. Double-click on the System icon.
3. Select the Performance tab.
4. If the PC Cards (PCMCIA) line does not read 32-bit, select
Start»Settings»Control Panel and double-click on the PC Card
(PCMCIA) icon.
The PC Card (PCMCIA) Wizard enables the 32-bit PCMCIA drivers.
5. Shut down your system and restart it.
Your system should detect your PCMCIA-GPIB or PCMCIA-GPIB+
interface.
EDVR Error Condition with ibcntl Set to 0xE0140004 (–535560188)
This error might occur if the GPIB interface has not been correctly installed
and detected by Windows. For instructions on how to install the GPIB
hardware, refer to the GPIB Hardware Guide on the NI-488.2 for
Windows CD. For instructions on accessing this manual, refer to the
Using the NI-488.2 Documentation section in About This Manual.
EDVR Error Condition with ibcntl set to 0xE1030043 (–519897021)
This error occurs if you have enabled DOS NI-488.2 support and attempted
to run an existing NI-488.2 DOS application that was compiled with an
older, unsupported DOS language interface.