National Instruments NI 8171 Series Network Card User Manual


 
Chapter 3 I/O Information
© National Instruments Corporation 3-9 NI 8171 Series User Manual
Trigger
The TRG connector is the software-controlled trigger connection for
routing PXI triggers to or from the backplane trigger bus.
Figure 3-7 shows the TRG connector location on the NI 8171 series.
Table 3-8 lists and describes the trigger connector signals.
Figure 3-7.
TRG Connector Location and Pinout
Table 3-8.
TRG Connector Signals
Pin Signal Name Signal Description
1 TRIG Trigger
2 (Shield) GND Ground
1
2