Filter
Top Products
English-10
Attaching Mounting Accessories
The display is designed for use with the VESA mounting
system.
1. Attach Mounting Accessories
Mounting accessories can be attached while the monitor
is on the Tabletop Stand in the upright position (Figure 1).
Be careful to avoid tipping monitor when attaching
accessories. After accessories are attached, stand can
be removed.
Mounting accessories can be attached with the monitor in
the face down position. To avoid damaging the screen face,
place the protective sheet on the table underneath the LCD
(Figure 2). The protective sheet was wrapped around the
LCD in the original packaging. Make sure there is nothing
on the table that can damage the monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the VESA-
compatible mounting method. NEC strongly recommends
using screws M6 size and 10mm in length. If using screws
longer than 10mm, check the depth of the hole.
(Recommended Fasten Force: 470-635N•cm)
NEC recommends using mounting interface that comply with
UL1678 standard in North America.
2. Installing and removing stand
CAUTION: Installing and removing the stand must be done
by two or more people.
How to install stand
1. Please turn monitor off.
2. Place stand onto monitor with the long ends of the feet in
front of the monitor.
3. After inserting stand in guide block, fasten thumbscrews
on both sides of the monitor.
How to remove the stand
1. Spread the protective sheet on a flat surface, such as a
desk.
2. Place monitor on the protective sheet.
3. Remove thumbscrews with a screwdriver or with your
fingers and place them in a safe place for reuse.
Figure 1
VESA Mounting Interface
Tabletop Stand
Thumbscrews
Stand
Figure 3
3. Ventilation Requirements
When mounting in an enclosure or in a recessed area allow
heat to disperse, leave space between surrounding the
monitor and surrounding objects allow heat to disperse, as
shown in Figure 3.
Protective Sheet
Tabletop Stand
Table
Figure 2
NOTE: Place stand onto monitor so that the long end of
the feet are in the front.
CAUTION: Handle with care when mounting LCD monitor
stand and avoid pinching your fingers.