Filter
Top Products
5. Using On-Screen Display
100
Control ID
Control ID selection allows units placed in close proximity to one another to have differ-
ent IR transmissions so only one unit is controlled at a time.
Assigning or Changing the Control ID:
(Available only when the optional remote control NP02RC is used)
1. Display the current control ID on the Control ID screen.
2. Press one of numeric keypad buttons while pressing and holding the ID SET button
on the remote control (NP02RC).
No ID means that all the projectors can be operated together with a single remote con-
trol. To set "No ID", enter "000" or press the CLEAR button.
Note:
TIP: The range of IDs is from 1 to 254.
3. Release the ID SET button.
Note:
The IDs can be cleared in a few days after the batteries are run down or removed.
Filter Message
Select the time preference between displaying the message for cleaning the filters.
Clean the filter when you get the message "Please clean filter." (see page 108)
Five options are available: Off, 100[H], 200[H], 500[H], 1000[H].
The default setting is 500[H]. Change the interval time depending on the degree of dust
and dirt on the filters.