Filter
Top Products
16
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
SELECT
3. Projecting an Image (Basic Operation)
This section describes how to turn on the projector and to project a picture onto the screen.
➊
Turning on the Projector
NOTE: Before turning on the projector, fi rst connect the supplied power cable's three-pin plug to the AC IN of the projector, and
then connect the other plug of the supplied power cable in the wall outlet. Make sure that the projector is in its standby mode
and the power indicator is glowing orange.
1. Remove the lens cap.
POWER
STATUS
LAMP
POWER
STATUS
LAMP
POWER
STATUS
LAMP
Standby Blinking Power On
Steady orange light Blinking green light Steady green light
See page 52 for more details.
UP
PAGE
OFF
POWER
ON
PIC-MUTE
DOWN
FOCUS
MENU
CAUTION:
Do not remove the lens cap by pulling on the string.
Doing so can cause mechanical damage to the part
around the lens.
2. Press the POWER (ON/STAND BY) button on the
projector cabinet or the POWER ON button on the
remote control for 1 second.
The POWER indicator will turn to green and the projec-
tor will become ready to use.
TIP:
* Turning on the projector will instantly cause the Auto Focus
function to operate. (→ page
22)
* When the key lock symbol ( ) is displayed at the bottom
right of the menu, it means that the Control Panel Lock is
turned on. (→ page
42)
After you turn on your projector, ensure that the com-
puter or video source is turned on and that your lens
cap is removed.
NOTE: When no signal is available, a blue or black screen is dis-
played.
When the projector displays a blue or black screen, the projector
will automatically switch to the Eco mode.
The projector will return to the Normal mode once a signal is con-
nected.
NOTE: If you turn on the projector immediately after the lamp is
turned off or when the temperature is high, the fans run without
displaying an image for some time and then the projector will dis-
play the image.
CAUTION:
The projector cannot be turned off while the POWER
indicator is blinking green.
• Do not turn off the AC power during this period.
Doing so could cause premature lamp failure.