Filter
Top Products
27
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
SELECT
❼
Turning off the Projector
To turn off the projector:
3. Projecting an Image (Basic Operation)
ENTER
EXIT
MENU
UP
PAGE
OFF
POWER
ON
PIC-MUTE
DOWN
FOCUS
First, press the POWER (ON/STAND BY) button on the
projector cabinet or the POWER OFF button on the re-
mote control. The “Power Off / Are you sure?” message
will appear.
❽
After Use
Preparation: Make sure that the projector is turned off.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt foot and rear foot if extended.
4. Cover the lens with the lens cap.
5. Put the projector and its accessories in the supplied soft case.
Secondly, press the ENTER button or press the POW-
ER (ON/STAND BY) or the POWER OFF button again.
The power indicator will glow orange.
Immediately after turning on the projector and display-
ing an image, you cannot turn off the projector for 60
seconds.
POWER
STATUS
LAMP
POWER
STATUS
LAMP
POWER
STATUS
LAMP
Power On Fan running Standby
Steady green light Blinking or-
ange light
Steady orange
light
CAUTION:
Parts of the projector will become heated during operation. Use caution when picking up the projector immedi-
ately after it has been operating.
CAUTION:
Use caution when putting the projector in the soft case immediately after the projector has been operating.
The projector cabinet is hot.
About Direct Power Off
The projector has a feature called "Direct Power Off". This feature allows you to unplug the projector when project-
ing an image.
NOTE: Do not turn off the projector using the "Direct Power Off" function within 10 seconds of making adjustment or setting
changes and closing the menu. Doing so can cause loss of adjustments and settings.