Filter
Top Products
E–24
3.OPERATION
This section describes how to select a computer or video source, how to
adjust the picture, and how to customize the menu or projector settings.
General Controls
Before you turn on your projector, ensure that the computer or video source
is turned on and that your lens cap is removed.
1. Turn on the Projector
Plug the supplied power cable in the wall outlet. The projector will go
into its standby mode and the power indicator will glow orange.
Only after you press the “POWER” button on the projector cabinet or the
remote control will the power indicator turn to green and the projector
become ready to use.
NOTE: To turn the projector on by plugging in the power cable, use the
menu and enable the “Auto Start” feature. (See page E-32.)
NOTE: Regardless of the lamp mode setting, the lamp always stays in
High-Bright mode for 3 minutes after the projector is turned on. If you
have selected the Eco mode, the STATUS indicator blinks green and the
lamp will change to Eco mode in 3 minutes.
NOTE: Immediately after turning on the projector, screen flicker may
occur. This is not a fault. Wait for 3 to 5 minutes until the lamp lighting is
stabilized.
2. Select the Computer or Video Source
Press the Source button on the remote control or the projector cabinet to
select “Video” (VCR, document camera, or laser disc player), S-Video”
or “RGB” (computer or DVD with component output) to display the im-
age.
Or press the “Menu” button on the remote control or the cabinet and use
the menu to select your video source: “Video”, “S-Video” or “RGB”.
3. Adjust the Image Size and the Focus
Use the Zoom lever to adjust the image size, then use the Focus ring to
obtain the best focus.
Use the “Magnify” button (+) or (-) on the remote control to make the
image larger up to 400%.
4. Turning off the Projector
First press the “POWER” button on the projector cabinet or the remote
control for a minimum of two seconds. The power indicator will glow
orange. After the projector turns off, the cooling fans keep operating for
30 seconds.
Do not disconnect the power cable during this time. Then, unplug the
power cable. The power indicator will go out.
IMPORTANT:
• The projector should be unplugged if it will not to be used for an ex-
tended period.
• To turn off the image and sound briefly (five minutes or less), use the
“Picture Mute” button instead of turning the projector off and on.
• The projector will display a black, blue image or logo if no input signal
is present.
• Do not turn the projector off and then immediately back on. The pro-
jector needs to cool for 30 seconds before it can be restarted.
POINTER
SELECT
Vol.
Vol.
MAGNIFY
MAGNIFY
2) Move the pointer to the area you want to enlarge.
3) Adjust the image size up to 400 percent.
Enlarging and Moving a Picture
You can enlarge the area you want up to 400 percent.
To do so:
1) Press the POINTER button on the card remote control to dis-
play the pointer.
CAUTION
Avoid displaying stationary images for a prolonged period of
time.
Doing so can result in these images being temporarily sustained
on the surface of the LCD panel.
If this should happen, continue to use your projector. The static
background from previous images will disappear.