Filter
Top Products
Rev. 1 - YML675 www.netcomm.com.au
NP5410 Wireless Ethernet Bridge User Guide Page 11
Wireless Navigator Installation
The Wireless Navigator Utility is provided to allow users to find and easily configure the
NP5410 through any Windows-based PC. This section describes procedures for installing the
Wireless Navigator Utility to PC.
Note: Please make sure that your PC already has TCP/IP protocol installed. If not, please
contact your administrator for details if you have problems of setting up this TCP/IP
protocol in your PC.
Note: Even your NP5410 is not connected with PC, but other Ethernet device, such as
printer server. You still can install the Wireless Navigator in any PC located in the
same IP subnet with the NP5410. This utility can search the NP5410 via both wired
and wireless Ethernet so that you still manage the NP5410 remotely.
1. Insert the installation CD-ROM into the CD-ROM drive. Run SETUP.EXE program on the
CD-ROM. The following window will be displayed.
2. After the InstallShield Wizard preparation finishes, the following window will be shown.
Click the Next button to continue.