Filter
Top Products
Rev.1 - YML655 www.netcomm.com.au
NP6800 - Wireless LAN Access Point Page 29
Point to MultiPoint
This mode allows you to construct a network that has multiple Wireless Access Point units
bridging LANs.
To configure a Point to MultiPoint bridged environment:
1. Click Point to MultiPoint for the NetComm NP6800 Wireless LAN Access Point used in
LAN 1. No MAC Address binding is needed.
2. Set the Access Points in LAN 2 and LAN 3 to Point to Point, and have them look for the
MAC Address of the Access Point in LAN 1.
Note: Only one of the Access Points must be in Point to MultiPoint mode. For all other
bridged Access Points, select the Point to Point option, and enter the Remote MAC
Address of the Access Point set to Point to MultiPoint.
3. Click the OK button to store the information.