Filter
Top Products
Rev.1 - YML655 www.netcomm.com.au
NP6800 - Wireless LAN Access Point Page 9
3. Connect a standard UTP ethernet cable to the Wireless Network Access Point.
Then, connect the other end of the Ethernet cable to a switch or hub or computer with a
Network Interface Card installed. The Wireless Network Access Point will then be
connected to your 10/100 Network.
4. Connect the AC Power Adapter supplied to the Access Point’s power socket.
5. Connect the appropriate end of the USB Cable to the Wireless Network Access Point’s
Configuration Port. Connect the other end to the USB port on your PC. Your system will
immediately recognize the Access Point and attempt to install drivers for it. Refer to the
appropriate operating system section for instructions on how to install the drivers.
Note: Once your Access Point is installed and configured, the USB cable may be
removed.