Filter
Top Products
Troubleshooting
127
N300 Wireless Router WNR2000v4
Troubleshoot with the LEDs
After you turn on power to the router, the following sequence of events should occur:
1. When power is first applied, verify that the Power LED
is on.
2. V
erify that the Power LED turns amber within a few seconds, indicating that the self-test is
running.
3. After approximately 30 seconds, verify that:
• The Power LED is solid green.
• The Internet LED is lit.
• A numbered Ethernet port LED is on for any local port that is connected to a
computer
. This indicates that a link has been established to the connected device.
You can use the LEDs on the front panel of the router for troubleshooting.
Power LED Is Off or Blinking
• Make sure that the power cord is securely connected to your router and that the power
adapter is securely connected to a functioning power outlet.
• Check that you are using the 12V DC,1A or 12V DC, 0.5A power adapter that NETGEAR
supplied for this product.
• If the Power LED blinks slowly and continuously
, the router firmware is corrupted. This
can happen if a firmware upgrade is interrupted, or if the router detects a problem with the
firmware. If the error persists, you have a hardware problem. For recovery instructions, or
help with a hardware problem, contact technical support at www.netgear.com/support.
Power LED Stays Amber
When the router is turned on, the Power LED turns amber for about 20 seconds and then
turns green. If the LED does not turn green, the router has a problem.
If the Power LED is still amber 1 minute after you turn on power to the router:
1. T
urn the power off and back on to see if the router recovers.
2. Press and hold the Restore Factory Settings button to return the router to its factory
settings.
For more information, see Factory Settings on page 136.
If the error persists, you might have a hardware problem and should contact technical
support at www.netgear.com/support.
All LEDs Remain Lit after Startup
When the router is turned on, the LEDs light for about 10 seconds and then turn off. If all the
LEDs stay lit, there is a fault within the router.