Filter
Top Products
Advanced Settings
82
N300 Wireless Router WNR2000v4
5. Select the Turn off wireless signal by schedule check box to activate the schedule.
6. Click the Apply button.
Set Up the WPS Settings
You can control how WPS functions on the router. NETGEAR recommends that you use
caution changing the WPS settings.
Note: For information about how to use WPS to add wireless devices and
other equipment to your wireless network, see
Wi-Fi Protected Setup
(WPS) Method on page 23.
You cannot set up the WPS settings when the security is WEP. Make sure that the security
mode is WPA-PSK, WPA2-PSK, or WPA-PSK + WPA2-PSK Mixed Mode. For information
about configuring the security mode, see
Basic Wireless Settings on page 27.
You can do the following with the router’s PIN:
• Disable the PIN entirely.
• Change the number of times that a PIN connection is allowed to fail before the PIN is
automatically disabled. By default, the PIN is automatically disabled after three failed
connection attempts. If the PIN is automatically disabled, it remains so until you restart
the router. While the PIN is disabled, the WPS LED blinks slowly.
• Turn off automatic disabling of the PIN.
To change the WPS settings for your wireless network:
1. Select Advanced > Advanced Setup > Wireless Settings.
The Advanced Wireless Settings screen displays.
The router’s PIN is shown for information only. It cannot be changed.
2. (Optional) Clear the Enable Router’s PIN check box to disable the router’s PIN entirely.
By default, the PIN is enabled, but there might be situations in which you want to disable
the PIN.
3. (Optional) Under the Enable Router's PIN check box, type a number in the field to change
the number of times that a PIN connection can fail.
You can change this setting only when the PIN is enabled. By default, the number is 3.
4. (Optional) Clear the check box under the Enable Router’s PIN check box to turn off
automatic disabling of the PIN.
You can change this setting only when the PIN is enabled. By default, automatic disabling
of the PIN is turned on.
5. (Optional) Clear the Keep Existing Wireless Settings check box.