Filter
Top Products
Basic Installation and Configuration 3-1
202-10101-01, 4 May 2005
Chapter 3
Basic Installation and Configuration
This chapter explains how to install and configure and the WPN802 Access Point on your
network. The first time you configure the WPN802 Access Point it must be connected with an
Ethernet cable to a computer with a broadband Internet connection.
Default Factory Settings
The WPN802 default factory settings are shown below. After you install the WPN802 Access
Point, customize any of the settings to better meet your networking needs.
FEATURE DEFAULT FACTORY SETTINGS
User Name (case sensitive) admin
Password (case sensitive) password
Operating Mode Access Point
Access Point Name netgearxxxxxx where xxxxxx are the last six digits of
the wireless access point’s MAC address
Built-in DHCP client DHCP client disabled
SIP Configuration
(if DHCP server is unavailable)
IP Address: 192.168.0.231
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Network Name (SSID) NETGEAR
Broadcast Network Name (SSID) Enabled
802.11b/g RF Channel 6
Mode Auto 108
AutoCell Enhanced RF Security ‘stealth’ mode Disabled
WEP/WPA Disabled
Restricting connectivity based on MAC Access
Control List
Disabled