Filter
Top Products
Reference Manual for the NETGEAR RangeMax™ Wireless Access Point WPN802
4-10 Wireless Configuration
202-10101-01, 4 May 2005
1. Log in to the WPN802 at its default LAN address of http://192.168.0.231 with its default user
name of admin and default password of password, or using whatever LAN address and
password you have set up.
2. Click Wireless Settings in the main menu of the WPN802.
3. From the Security Options menu, select WEP/WPA. The WEP/WPA Settings page opens.
Figure 4-6: Wireless Settings encryption menu
4. Select the Network Authentication and Data Encryption from the drop-down lists.
Please refer to “Authentication and WEP Data Encryption” on page B-2 for a full explanation
of each of these options, as defined by the IEEE 802.11 wireless communication standard.
5. Either enter a Passphrase and click Generate Keys, or manually enter the keys. The keys must
be identical on all computers and access points in your network.
• Passphrase - The passphrase is case sensitive; NETGEAR is not the same as nETgear. The
four key boxes will be automatically populated with key values.
• Manual - Enter ten hexadecimal digits (any combination of 0-9, a-f, or A-F). These entries
are not case sensitive; AA is the same as aa.
Note: If you use a wireless computer configure WEP settings, you will be disconnected
when you click Apply. You must then either configure your wireless adapter to match
the wireless access point WEP settings or access the wireless access point from a wired
computer to make any further changes.