Filter
Top Products
Reference Manual for the NETGEAR RangeMax™ Wireless Access Point WPN802
Basic Installation and Configuration 3-3
202-10101-01, 4 May 2005
2. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 as the
Subnet Mask.
3. Connect an Ethernet cable from the WPN802 to the computer.
Figure 3-1: WPN802 connected to a computer during configuration
4. Turn on your computer, and connect the power adapter to the WPN802. Then check the lights
on the front:
• Power: The power light should be lit. If the power light is not lit, check the
connections and check to see if the power outlet is controlled by a wall switch that is
turned off.
• Test: The test light blinks when the WPN802 is first turned on.
• WLAN: The wireless light should be lit.
• Ethernet: The Ethernet (LAN) light should be lit (amber for a 10 Mbps connection
and green for a 100 Mbps connection). If not, make sure the Ethernet cable is securely
attached at both ends.