Filter
Top Products
ASI-IP-GTW User's Manual
Page 27
To select a page, just click on the tab of the page you want to view.
Main tab (page) Sub-tab Description
Current alarms The current status of the unit is shown. The page
shows pending alarms together with information
about when the alarm appeared and the severity level
of the alarm.
Status
Alarm log The alarm log shows past alarms. Current alarms are
not shown on alarm log.
This gives information about the serial number and
software version of the unit. In addition, the user can
assign a name to the unit. The user can also change
the operation mode (IP Transmit , IP Receive or both)
or manually reset the device from this page.
Network This is where IP address, subnet mask and default
gateway is defined for management interface and
data interface. In addition, for the data interfaces, the
Advanced tab provides configuration of in-band
management. The SFP tab provides information
about the SFP.
Time settings Set SNTP server address. Current time is shown if
valid SNTP server is already defined.
Device Info
Alarms Provides a list of all alarms and configuration of
severity level for the alarm events.
SNMP Set Trap Destination Servers.
Ping A page offering an interface to check for connectivity
by pinging a remote host.
Security Enable or disable password protection, and change
password.
RIP-2 Show status, and change parameters for the Routing
Information Protocol
This is where each input is configured
Main This is where the main parameters of each input are
configured. In addition, status of each stream is
shown.
FEC This is where the FEC parameters are configured.
IP TX
Ethernet This is where VLAN tagging, and Static MAC is
configured.
Ping This is where Ping parameters for the IP channel is
configured.
IP RX This is where the outputs are configured.
Main This is where the main parameters of the outputs are
configured.
FEC This is where the FEC parameters are configured.
Ethernet This is where VLAN tagging, and Static MAC is
configured.
Ping This is where Ping parameters for the IP channel is
configured.
Advanced Advanced parameters related to buffer regulator.
Network Overview of IP addresses UDP ports and bitrates.
Save/Load Save and load of configurations.