Network Technologies Console Switch Switch User Manual


 
NTI SERIMUX SERIES CONSOLE SWITCH
24
¾
Verbose mode
Send or type in:
[V] [Enter]
The answer will be:
OK [CR][LF]
and the Terse mode will be terminated. The “Accessible host list” or the “User main menu” will be displayed.
Note: Once a user configured for Terse mode login exits Terse mode to enter Verbose mode, Terse mode login will no
longer be available at login. To return to Terse mode, the administrator must re-configure the user settings to enter
Terse mode at login.
¾ User Logout
Send or type in:
[L] [Enter]
The answer will be:
OK [CR][LF]
With the next login of the same user, Terse mode will resume.
KEYPAD CONTROL
Figure 21- Keypad and LEDs
Functions of the Keypad
During normal operation, the current administrator port number (if any) is displayed on the local front panel. The corresponding
port LED will be continuously illuminated. The data traffic between connected ports is indicated the blinking of the corresponding
port LEDs.
Using the keypad, anyone with physical access to the SERIMUX can:
¾ Login the administrator
¾ Logout the administrator
¾ Disconnect the administrator or a user with administrative privileges
¾ Login a user to the administrator main menu
¾ Disconnect and logout a user
¾ Connect 2 host ports
¾ Disconnect 2 ports
¾ Connect or disconnect a modem
FYI: Buttons pressed in sequence on the keypad to enter commands must be pressed within 5 seconds of each other for
the SERIMUX to respond. Otherwise, the sequence will need to be repeated from the beginning.
¾ Login the administrator
Note: In order to login the administrator to a port other than port 0, the administrator must first configure the desired
port as a user port (see page 10 ). By default, all ports, other than 0, are configured as host ports.
Action (from Keypad) Reaction of SERIMUX
1. Press ADMIN - The LED “Admin” will illuminate. The port 0 LED will be illuminated, the other port LEDs will
be OFF.
2. Enter port number (00 by
default
- The corresponding port LED will illuminate. The other port LEDs will be OFF.
3. Press ENTER - The administrator port LED will illuminate. The data traffic of other linked ports (if any) will
be displayed again by flashing the corresponding port LEDs.
- The administrator main menu (Fig. 4, page 7) will be displayed on the terminal application
running on the administrator port.
1
0246
35
8
7
10
9
12
11
14
13
16
15 Port Admin User Discon
ESC
ADMIN USER
PORT
6
12345ENTER
DISCON7890
Front View of SERIMUX