Filter
Top Products
Control keypad
67(86)
7
7.3.6.1 Application selection
The user can select the application desired by entering the Application selection page (S6.1). This
is done by pushing the right arrow menu button when on the first page of the System menu.
Change the application by pushing the right arrow menu button once again. The name of the
application starts to blink. Browse through the applications with the Browser buttons and select
another application with the Enter button.
In this phase, the display requests whether theparameters of the
new
application are to be
uploaded to the keypad. If so press the Enter button Pushing any other button leaves the
parameters of the
previously used
application saved in the keypad. For more information, see
Chapter 7.3.6.5.
For more information about the Application Package, see the NX Application Manual.
Figure 7-9. Change of application
7.3.6.2 Language selection
The HMI control keypad offers the user the possibility to control the frequency converter through
the keypad in the language of your choice.
Locate the language selection page under the System menu. Its location indication is
S6.2
. Press
the right arrow menu button once to enter the edit mode. As the name of the language starts to
blink choose another language for the keypad texts. Confirm the selection by pushing the Enter
button The blinking stops and all textual information on the keypad is presented in the language
chosen.
Return to the previous menu anytime by pushing the left arrow menu button.
System Menu
S1
"
S11
STOP READY
I/Oterm
Application
Standard
STOP READY
I/Oterm
Application
Standard
STOP READY
I/Oterm
enter
Application
Multi-step
STOP READY
I/Oterm