Filter
Top Products
|
Feature Set Guide: English 125
DHCP
DHCP Setting (On or Off)
The factory default setting for DHCP is ON.
You use the IPFax Console Software to change the setting for
DHCP from ON to OFF.
When DHCP is ON, and the unit is connected to a network
that employs a DHCP server, the unit will automatically be
assigned an IP Address.
If you use this method, the DHCP server must be set to
infinite lease or reservation.
If you can’t use DHCP, use User Function 83 to initialize the
T.38 board. By doing this, DHCP is turned OFF. Then, use
User Functions listed below to make the appropriate settings.
· IP Address, User Function 80
· Subnet Mask, User Function 81
· Default Gateway, User Function 82
DHCP ON
When DHCP is ON, and no DHCP Server exists, the following
settings apply:
IP Address: 0.0.0.0
Subnet Mask: 0.0.0.0
Default Gateway: 0.0.0.0
DHCP OFF
The following settings apply when DHCP is turned OFF (by
initializing the T.38 board from the front panel of the
facsimile machine [User Function 8]:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.254