Filter
Top Products
C8800 User’s Guide
111
Network Menu
This menu controls the operation of the printer’s 10Base-T/
100Base-TX network interface.
Notes:
Factory default settings are shown in
bold.
Settings with a dagger (†) only appear when the
appropriate option is installed.
Item Settings Explanation
TCP/IP ENABLE /
DISABLE
Enables or disables this network
protocol.
IP VERSION IP V4 / IPV 4 &
V6
NETBEUI ENABLE /
DISABLE
Enables or disables this network
protocol.
NETWARE ENABLE /
DISABLE
Enables or disables this network
protocol.
ETHERTALK ENABLE /
DISABLE
Enables or disables this network
protocol.
FRAME TYPE AUTO / 802.2 /
802.3 /
ETHERNET II /
SNAP
Selects the Ethernet MAC layer frame
type.
IP ADDRESS
SET
AUTO /
MANUAL
Specifies whether IP address allocation
is automatic (DHCP) or manually
assigned.
IP ADDRESS xxx.xxx.xxx.xxx Current assigned IP address. To
change, press ENTER and use +/–
keys to increment 1st octet, then press
ENTER again to move on to next octet.
When 4th octet has been set, press
ENTER again to register new address.
SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. To
change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx Current assigned gateway address. To
change, proceed as above.
FACTORY
DEFAULTS
EXECUTE Reloads the settings present when the
unit was setup by the manufacturer.
WEB ENABLE /
DISABLE
Enables or disables Web config. facility.