Filter
Top Products
C8800 User’s Guide
136
4. Remove any sheets of paper on the belt unit (1).
Jams 1_1.eps
CAUTION! Do not use any sharp or abrasive objects to
separate sheets from the belt. This may damage the belt
surface.
Warning! If the printer has been printing, the fuser will be
HOT!
5. If the sheet is well advanced into the fuser (only a short
length is still visible), do not attempt to pull it back. See
step 4 under “Jam 382” .
To remove a sheet trapped in the fuser:
a. Grasp the edge of the sheet.
b. Push the fuser pressure release lever (1) towards
the front and down.
c. Lift out the sheet.
d. Let go of the fuser pressure release lever.
6. Place the four image drums/toner cartridges back in the
printer. Be sure to place them in the proper sequence
See Step 2.
7. Close the top cover.
1