Filter
Top Products
51
Status LEDs for the Head Check Setting Mode
Head checking can be applied to one of two areas: the
normal print area and the barcode print area. To specify
the area subjected to a head check, follow the settings in the
table below (cover must be left open):
You can check the current setting with a test printout as
described in “Performing a Test Print” on page 38.
When setting the Head Check options, the STATUS LED blinks
green, and turns into a steady green signal upon completion
of setting. Turn off the printer ONLY when the STATUS LED is
a steady green light.
Status LEDs for the Online Command
Compatibility Mode
The printer can be set for compatibility with SBPL commands
or with the older MB200 commands.
You can check the current setting with a test printout as
described in “Performing a Test Print” on page 38.
H.Check
setting
DSW-1 DSW-2 DSW-3 DSW-4 Other keys
Normal Print
Area
OFF ON OFF ON hold down
PRINT button
Disable H.
Check
OFF ON OFF ON hold down
FEED button
Barcode Print
Area
ON OFF OFF ON hold down
PRINT button
Disable H.
Check
ON OFF OFF ON hold down
FEED button
Compatibility DSW-1 DSW-2 DSW-3 DSW-4 Other keys
LP440-
compatible
online
commands
ON ON ON ON hold down
PRINT button
SBPL online
commands
ON ON ON ON hold down
FEED button