Filter
Top Products
E-30 Pacemark 4410 Setup Guide
damaging the printhead. Other paper widths must be set
using your software application.
To change the menu setting to 8 inches, turn the printer on,
then:
a. Press MENU.
b. Press GROUP until Rear Feed appears on the display.
c. Press ITEM until Page Width appears on the display.
d. Press OPTION once to switch to the 8-inch setting.
e. Press STORE to save the 8-inch setting.
f. Press MENU to exit the menu mode.
The Top of Form (TOF) for the rear feed paper path is set at the factory
to 0.35 inch (9 mm) down from the top of the page. If this setting does
not suit your application, you will need to set the Top of Form: see
“Setting Top of Form” in the Front Panel Overview section of this
Setup Guide.
Switching Paper Paths
The Pacemark 4410 is set at the factory for software control of the
paper path. You can enter the menu and change this so that the printer
will automatically switch to the alternate path when paper runs out. To
do this:
1. With the printer turned on, press MENU.
2. Press GROUP until Set-Up appears on the display.
3. Press SHIFT + ITEM until Auto Path appears on the display.
4. Press OPTION.
Valid will appear on the display.
5. Press STORE.
An asterisk (*) will appear next to Valid.
6. Press MENU to exit the menu and engage the settings.