Filter
Top Products
E-4 Pacemark 4410 Setup Guide
• To avoid damaging the power cord, do not put anything on it or place
it where it will be walked on. If the cord becomes damaged or frayed,
replace it immediately.
• If you’re using an extension cord or power strip with the printer,
make sure that the total of the amperes required by all the equipment
on the extension is less than the extension’s rating. Generally, the total
ratings of all equipment plugged into any one power line should not
exceed 15 amperes. Don’t exceed this unless you know that the power
line your equipment is plugged into has a rating above 15 amperes.
• Do not poke anything into the ventilation slots on the sides of the
printer; you could get a shock or cause a fire.
• Aside from the routine maintenance described in Section 2 of the on-
line Pacemark 4410 User’s Guide, don’t try to service the printer
yourself; opening the cover may expose you to shocks or other
hazards. Don’t make any adjustments other than those outlined in the
Pacemark 4410 User’s Guide - you might cause damage requiring
extensive repair work.
• If anything happens that indicates that your printer is not working
properly or has been damaged, unplug it immediately and follow the
procedures in Section 4 of your on-line Pacemark 4410 User’s Guide
for having your printer serviced. These are some of the things to look
for:
- The power cord or plug is frayed or damaged.
- Liquid has been spilled into the housing, or the printer has been
exposed to water.
- The printer has been dropped or its cabinet has been damaged.
- The printer doesn’t function normally when you’re following the
operating instructions.