Filter
Top Products
– 12 –
3-7. Loading the Paper Roll
Be sure to use paper roll that matches the printer’s specication.
Cover open lever
Paper roll
Tension bar
カバーオープンレバー
Push the cover open lever and open the printer
cover.
For the RX model:
Turn the key under the cover open lever so that the
lock is "OPEN." Then, push down on the cover
open lever and open the printer cover.
The key cannot be removed when the lock is
"OPEN." Before you remove the key, turn it so
that the lock is in the "CLOSE" position.
Set the paper roll in the direction as shown, and
pull on the leading edge of the paper towards you.
Note: Make sure not to pass the paper under the
tension bar. In the following condition,
remove the tension bar unit in accordance
with the procedure described in paragraphs
3-7-1:
• Paper thickness between 100 μm and
150 μm
Note: When using a paper roll with an 79.5 mm
width, attach the paper roll holder in ac-
cordance with the procedure described in
paragraph 3-7-2.
Push both sides as shown in order to close the
printer cover.
Note: When closing the printer cover, make sure
both sides close rmly, not just one side.
CLOSE
OPEN