Filter
Top Products
– 26 –
Adjustment value according to the paper you are using
Paper thickness
(µm)
When using the paper roll with a core whose inside diameter (A):ø12, outside diameter
(B):ø18
Detected diameter (C)
(Approx. mm)
Remained paper length
(Approx. m)
Level 1 Level 2 Level 3 Level 1 Level 2 Level 3
65 ø23 ø27 ø31 2.5 4.9 7.7
75 2.1 4.2 6.7
Paper thickness
(µm)
When using the paper roll with a core whose inside diameter (A): ø25.4, outside di-
ameter (B):ø32
Detected diameter (C)
(Approx. mm)
Remained paper length
(Approx. m)
Level 1 Level 2 Level 3 Level 1 Level 2 Level 3
65 ø36 ø40 ø44 2.8 6.4 10.4
75 2.4 5.5 9.0
85 2.1 4.9 7.9
95 1.9 4.4 7.1
105 1.7 4.0 6.4
130 1.4 3.2 5.2
150 1.2 2.8 4.5
Note:
1) The adjuster is factory-set at level 1 on the horizontal
layout and level 3 on the vertical/wall-mount layout.
2) The detected diameter and remained paper length
given above are calculated values, and there may be
some variances depending on the rolled state of the
paper or the actual mechanism.
3) If thick paper is used (paper thickness between 100 μm
and 150 μm), the paper roll may loosen and cause
variances in the detected values. Therefore, set the
adjustor to Level 3 for horizontal layout.
4) The near end sensor doesn't correspond to the thermal
label paper roll (tack label paper).
C
C
B
A
Paper roll core