Filter
Top Products
– 42 –
No. 1 2 3 4 5 6 7 8 No. 1 2 3 4
9 10
DIP-SW 1 DIP-SW 2
10-3. USB Interface Model
ON ON
OFF OFF
DIP-SW 1
Switch 1-1 Switch 1-2 Command emulation
ON ON Star Line Mode
OFF ON Star Page Mode
ON OFF -
OFF OFF ESC/POS Mode
The factory settings of DIP switch are all on.
The functions of switches 1-3 through 1-10 will change according to the command emulation
that has been set using switch 1-1 and 1-2.
(1) Star Line Mode
Switch Function ON OFF
1-1 Command emulation Always ON
1-2 Command emulation Always ON
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment Invalid Valid
1-5 USB mode Printer class Vendor class
1-6 Handshaking conditions
(conditions for BUSY)
Ofine or receive
buffer full
Receive buffer full
1-7 ASB function *1 Printer class Valid Invalid
Vendor class Invalid Valid
1-8 NSB function *2 Printer class Valid Invalid
Vendor class Invalid Valid
1-9 ~1-10 Should not be changed (Should be set to on)
*1 ASB Function
When this function is enabled, status information is automatically sent to the host whenever the
printer status changes (such as when the cover is opened, paper runs out, or an error occurs).
For information about automatic status information transmission, refer to the separate Program-
mer's Technical Reference manual (Star Line Mode, Star Page Mode, and ESC/POS Mode).
*2 NSB Function
When this function is enabled, status information is sent automatically whenever the printer
enters into reverse forwarding mode.
For information about automatic status information transmission, refer to the separate Program-
mer's Technical Reference manual (Star Line Mode and Star Page Mode).