Filter
Top Products
– 32 –
9-2. Auto Cutter Specications
(1) Cutting frequency Max. 20 cuts per minute
(2) Thickness of paper 0.065 ~ 0.15 mm (when using 115.5 mm width paper)
0.065 ~ 0.085 mm (when using 79.5 mm width paper)
9-3. Interface
RS-232C serial interface / Two-way parallel interface (IEEE1284) / USB interface / Ethernet
interface
9-4. AC Adapter (Option)
(1) Operating Voltage Input Voltage: 90 to 264 V AC, 50/60 Hz
Output Voltage: DC 24 V±10%
(2) Current Consumption (DC 24 V at room temperature)
Standby: Approx. 0.12 A
ASCII printing: Approx. average 2.0 A
(Approx. 17.5% printing rate)
100% print duty: Approx. peak 8.6 A
(Solid printing): Approx. average 4.2 A
(Continuous solid printing should be 50 mm or less.)
(3) Power Connector
Pin No. Function
1 Drive power (24 V)
2 Signal GND
3 N.C.
Shell Frame ground
Note:
• When using a printer power supply other than the optional AC adaptor (PS60A-24 se-
ries), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ± 5% and more than 2.0 A (5.0 A Load 10 sec. Max.)
with SELV output and LPS or Class 2 output approved by IEC60950-1.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.
<Viewed from Connector Surface>
1
2
3