Filter
Top Products
Manual No. 25-ULPNR102-01; Mar, 2005 LMD 1135 Laser Fixed Mount Scanner
Page 23
Scanner Timeout (Trigger Enabled
Mode)
Y1 1 second after triggering
Y2 2 second after triggering
Y3 3 second after triggering
Y4 4 second after triggering
Y5 5 seconds after triggering
Y6 6 second after triggering
Y7 7 seconds after triggering
Y8 8 seconds after triggering
Y9 9 seconds after triggering
YL Read time x 10
YM Indefinitely after triggering
XA Add-on Wait Time - Disable
XB Add-on Wait Time – 250 msec
XC Add-on Wait Time – 500 msec
XD Add-on Wait Time – 750 msec
AH Multiple Read Reset Time – 50 msec
AI Multiple Read Reset Time – 100 msec
AJ Multiple Read Reset Time – 200 msec
AK Multiple Read Reset Time – 300 msec
AL Multiple Read Reset Time – 400 msec
AM Multiple Read Reset Time – 500 msec
AN Multiple Read Reset Time – 600 msec
AG Multiple Read Reset Time - Indefinite
Quiet Zone Options
YN No margin check
YO Margin check 1/7 nominal
YP Margin check 2/7 nominal
YQ Margin check 3/7 nominal
YR Margin check 4/7 nominal
YS Margin check 5/7 nominal
YT Margin check 6/7 nominal
YU Margin check normal
Redundant Decoding
X0 Read bar code once
X1 Read bar code twice before transmitting
X2 Read bar code three times before transmitting
X3 Read bar code four times before transmitting
BS Read bar code five times before transmitting
BT Read bar code six times before transmitting
BU Read bar code seven times before xmitting
BV Read bar code eight times before xmitting
BW Read bar code nine times before xmitting
Xmit Error (Trigger Enabled Mode only)
TH User defined error message for no label
TI User defined error message for no decode
TG Clear error messages for no label, no decode
WD Response to command - None
WC Response to command – OK=ACK,
ERROR=NAK
WB Buzzer Control to Command - Disable
WA Buzzer Control to Command - Enable
Good Read LED Operation
T4 Disable good read LED (GRL)
T5 GRL ON for 0.20 seconds after decode
T6 GRL ON for 0.40 seconds after decode
T7 GRL ON for 0.80 seconds after decode