Filter
Top Products
Manual No. 25-ULPNR102-01; Mar, 2005 LMD 1135 Laser Fixed Mount Scanner
Page 1
Section 1
Introduction and Getting Started
Product Overview
The LMD 1135 Fixed Position Scanner is a miniature, 100 scan per second, laser bar code reader
designed to be easily incorporated into host equipment. The small physical size makes the scanner easy
to integrate into any hardware design. Durability and reliability are assured.
Advanced microprocessor technology coupled with Opticon’s proven decoding algorithms result in high
speed operation with superior accuracy. The scanner is fully programmable allowing the user to
customize parameters including changing communication settings, selecting symbologies, adding prefixes
and appending suffixes. Programmable settings can be downloaded from the host CPU or computer
directly to the scanner.
The scanner is encased in a compact, rugged, yet lightweight-plastic enclosure. The compact size
permits installation in the tightest areas allowing great flexibility in mounting and positioning the scanner
for optimum performance.
Quick Start-Up Procedure
This section is for those who wish to start using the scanner before reading the complete manual. In
only a few steps the scanner will be operable.
Turn off the power to your PC and connect the scanner to an RS232 communications port. Note: You
must provide +5 Volt DC power to the scanner. If you are using our standard LPN1137RR1S-050 or have
purchased the evaluation kit, you can utilize power supply, P/N 32-00907-01, by plugging its connector
directly into the pigtail connector on the scanner. If the power supply is obtained from another source
verify that it is identified with the
CE
mark. Turn on the power to the PC.
1) Using communications software (e.g., Procom), set the communication parameters: 9600 baud,
1 Start/Stop Bit, 8 Data Bits, No Parity, No Handshaking, No Flow Control
2) If you are operating in a Microsoft Windows 3.1 environment, skip to Step 5.
3) If you are operating in a Microsoft Windows 95/98/ 2000/ XP environment, you can set the
communication parameters using Hyper Terminal as follows:
♦ Open Hyper Terminal. This can be done from Start→Programs→Accessories/
Communications
♦ Select Hypertrm.exe to create a New Connection
♦ In the Connection Description dialog screen enter a name for the new file. If desired, select
an Icon. Click OK
♦ In the
Connect To
(
Phone Number)
dialog screen, in the box entitled:
Connect using
. select
the communication port, for example, “Direct to Com 1” Click OK
♦ In the
Com 1 Properties
screen, enter the appropriate Port Settings: Bits per second = 9600,
Data bits = 8, Parity = None, Stop Character = 1, Handshaking = None, Click OK
♦ The hyper-terminal folder you just created will open. From the File pull-down menu, select
Properties
then click on the
Setting
Tab