Filter
Top Products
55555
Packard Bell EasyNote MT Disassembly Manual
5
2. Lift the cover upwards from the right. There are two tabs holding the cover in place on the
left. Raise the cover until you can remove it from the casing (see Fig. 2).
3. Pull the plastic tab on the hard disk drives towards the left to disconnect the drive.
Fig. 3 Disconnecting and removing hard disk drive.
4. Take the drive out of the compartment (see Fig. 3
).
5. Remove the four screws (Phillips-head) on the metal bracket holding the hard disk drive.
Fig. 4 Separating hard disk drive from bracket.
Note:
In Fig. 4
only two screws are visible; the other two are located on the other side of the bracket.
Memory
To remove the memory installed, first remove the battery (see Battery on page 4) and then perform
the following steps: