Filter
Top Products
Modifications Upgrading Software
Centillion 1200N ATM Switch User Manual 10-21
NTP 297-8103-903
FLASH_UP_SAVE Mode
Load the software from the ATA card mounted in the PCMCIA slot #0. The office
data is loaded from the ATA card mounted in the PCMCIA slot #1. After loading,
the office data is saved to the ATA card mounted in the PCMCIA slot #0.
Figure 10-25: FLASH_UP_SAVE Mode
Procedure
1.
Turn off the power of the ATM Switch.
2.
Insert the new version ATA card in PCMCIA slot #0 and the ATA card
containing the office data you wish to continue to use in PCMCIA slot #1.
3.
Turn on the power of the ATM Switch and start the boot monitor.
4.
Set the boot mode as follows:
BOOT# SET boot flash_up_save
5.
End the boot monitor:
BOOT# QUIT