Filter
Top Products
35
Operating
Instructions
Concerning the wireless remote control
(optional accessory)
This unit can be operated by remote control using a
wireless remote control (model number: AW-RM50G)
purchased separately.
Check out the following points before using the wireless
remote control.
Consult your dealer concerning the purchase of a
wireless remote control.
p Point the wireless remote control at the unit’s wireless
remote control signal light-sensing area (shown in the
figure on the below), and operate it within a range of
10 meters (32.8 ft) from these areas.
p The signal sensing distance is reduced if the angle at
which the wireless remote control signals are sensed
is increased.
The signal sensing sensitivity is approximately halved at
an angle of 40 degrees from the front of the signal light-
sensing area.
If the remote control is operated from the behind the
unit, it may be either difficult or impossible to perform the
desired operations.
Layout of wireless remote control signal light-sensing areas
45°45°
75°
75°
Wireless remote control
signal light-sensing
areas (2) at the side
Wireless remote control signal
light-sensing areas (2) at the front
p Top view
p If the unit is installed near fluorescent lights, plasma
monitors or other such products or if the unit is
exposed to sunlight, the effects of the light may make
it impossible for the unit to be operated using the
wireless remote control.
Be sure to follow the steps below for installation and use.
• Take steps to ensure that the light-sensing area will not
be exposed to the light from fluorescent lights, plasma
monitors or other such products or from the sun.
• Install the unit away from fluorescent lights, plasma
monitors and other such products.
p For about 10 minutes even after the batteries have
been removed from the wireless remote control,
the selection of the operation to be performed (the
[CAM1], [CAM2], [CAM3] or [CAM4] button which was
pressed last) will remain stored in the memory. When
a longer period of time elapses, however, the selection
is reset to the status established when the [CAM1]
button was pressed.