Filter
Top Products
33
Inserting/Removing
Removing the device
Turn your computer over and open the cover by sliding the latch A.
Slide and hold the latch B on the MP release lever, then turn the MP
release lever.
Remove the device by holding both sides of the device.
Handle the device as shown (holding both
sides). Otherwise, the device may be dam-
aged. Also, do not apply excessive down-
ward force on the device. The projections at
the bottom of a device become deformed.
Inserting the device
Gently insert the device into the multimedia pocket by pushing on both
corners until it clicks into place.
Do not insert the device upside-down.
The bottom of the drive may become disfigured.
CAUTION
CAUTION
NOTE
Cover
Latch A
MP Release Lever
Insert the device with the plastic
side on top.
Latch B
Multimedia Pocket
Whether the device is properly recognized or not can be confirmed in
[Information] of the Setup Utility. If the device is not recognized (or if a
CD/DVD cannot be read or an FD/HDD/CD-R/CD-RW cannot be read
or written to), power off the computer and reinsert the device.
When the CD drive is installed:
If the vibration of the CD drive is excessive, set the [CD Drive Speed]
to [Low] in the Setup Utility.
Do not insert/remove the multimedia pocket device in the standby or hibernation mode,
or when (multimedia pocket indicator) or (hard disk drive indicator) is on.
CAUTION