Filter
Top Products
49
The red indicator lights.
Repeated beeping sound
while the computer is in
use.
The red indicator blinks
The orange indicator
blinks
The battery level is low. Save your data and power off your computer.
After connecting the AC adaptor or replacing the battery pack with a fully charged
one, turn your computer on.
The battery pack or recharging function may be defective. Quickly remove the
battery pack and disconnect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support.
Unable to charge because of an improper temperature range. ( “Read Me
First - Precautions(Battery Pack)”)
Battery Indicator
Dealing with Problems (Advanced)
Only capital letters are
being input
How to input European
characters (ß, à, ç), sym-
bols or Euro Currency
Symbol is unclear
Character Input
If CapsLock is on, the Caps Lock function is ON. To switch it OFF, press
Caps Lock .
Windows 2000
Select [Start] - [Programs] - [Accessories] - [System Tools] - [Character Map].
Windows XP
Select [Start] - [All Programs] - [Accessories] - [System Tools] - [Character Map].
The Character Map will be displayed. Point to the desired font name and select it.
Shutting Down
Unable to input using the
touch pad
Touch Pad
Has the Setup Utility been used to set [Touch Pad] to [Enable]? ( page 40)
When mouse drivers are installed (e.g., Intellimouse), the touch pad is unable to
be used.
Has the touchpad driver been properly installed?
Windows cannot be shut
down or restarted
Do not shut down Windows during music playback.
If a USB device is connected, try removing it.
Was an attempt made to shut down (or restart) Windows while the computer was
connected to a network drive using a LAN?
With the following procedure, shut down (or restart) Windows after disconnecting
the network drive.
1 Windows 2000
Select [My Computer] on the Desktop with the right button of the touch pad.
Windows XP
Select [start] - [My Computer] with the right button of the touch pad.
2 Select [Disconnect Network Drive].
3 Select all of the displayed network drives, then select [OK].